Chapin 22090 User Manual download pdf

WARNING!

Printed in U.S.A.

1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.

2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of

these conditions are found, replace hose before using. Replace with original manufacturer’s

parts only.

3) Do: Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and

exterior of tank for signs of deterioration of body and bottom. Any sign of deterioration

indicates possible tank weakening and could result in explosive bursting under pressure. If any

of these signs are found, discard tank immediately and replace. Do not attempt to patch leaks,

etc., as this could result in serious injury.

4) Do: Follow Filling, Pressurizing and Spraying Instructions, except use water only.

5) Do: Pump plunger 8-10 strokes and inspect for leaks.

6) Do: Direct shut-oﬀ away from you and open to make sure discharge is not clogged.

7) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank,

and proceed with Filling, Pressurizing and Spraying Instructions.

3. Pre-Use Check

4. Filling

1) Do: Turn pump handle counterclockwise and remove pump

2) Do: Prepare spray solution following all directions and safety warnings on chemical label.

3) Do: Fill tank to no more than the proper gallon marker. Do NOT: over ﬁll to

accommodate pump.

4) Do: Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in

tank and tighten securely.

5. Pressurizing and Spraying

Do: Turn handle clock-

wise to tighten. Push

handle down, turn 1/4

turn counterclockwise to

release.

Do: Pump until

you feel resistance.

Do: Push handle,

down, turn 1/4 turn

clockwise to lock. Be-

gin spraying. Re-pump

sprayer as required to

maintain spray force.

7. To Release Pressure

1) Your sprayer is equipped with a pressure relief/release valve.

To release pressure lift and hold the cap until air is completely

exhausted, OR, turn the valve slowly counterclockwise until you

hear air escaping and wait air is completely exhausted.

2) Do: Stay away from the sprayer until all air has escaped.

8. Care, Storage and Maintenance

1) Do: Rinse tank thoroughly with water only, empty, reﬁll with water. Follow Filling,

Pressurizing and Spraying Instructions, except pump unit only 8-10 strokes.

2) Do: Open shut-oﬀ and allow water to run through discharge assembly.

3) Do: Release pressure (Follow Pressure Release Instructions), remove pump and empty

sprayer.

4) Do: Store sprayer tank upside down, with pump removed, in a warm dry location.

5) Do: Periodically oil pump by dropping 10-12 drops of light oil down pump rod through

opening in cover.

010538 (A) R0209

1. Hose to Tank

Make sure white out-

let tube is attached to

hose.

Insert tube into

tank.

Parts

WARNING: Handling the brass parts of this product will expose you

to lead, a chemical known to the State of California to cause birth

defects and other reproductive harm. Wash hands after handling.

2. Nozzle

Attach nozzle to extension wand.

1A 1B

Proper placement of

white outlet tube.

Line up tabs on safety

lock connector with

notches on the outlet

ﬂange of the tank. Insert

tabs into notches to

form a secure seal.

Slip hose nut down to

tank, turnclockwise and

tighten as tight as possible

by hand.

Hazard: Improper use or failure to follow instructions can result in explosive failure causing

serious eye or other injury. For safe use of this product you must read and follow all instructions.

Do not leave a pressurized sprayer in the hot sun. Heat can cause pressure build-up. Do not store

or leave solution in tank after use. Always wear goggles, gloves, long sleeve shirt, long pants and full

foot protection when spraying. Never use any tool to remove pump if there is pressure in sprayer.

Never stand with face or body over top of tank when pumping or loosening pump to prevent eject-

ing pump assembly and/or solution from striking and injuring you. Never pressurize sprayer by any

means other than the original pump. Do not attempt to modify or repair this product except with

original manufacturer’s parts. Never spray ﬂammable materials or heat, pressure, or gas produc-

ing chemicals. Always read and follow manufacturer’s instructions before use with this sprayer

as some chemicals may be hazardous when used with this sprayer.

Sk-1113-1

6-6136

Hose

Manguera

Tuyau

6-7742

Extension wand, Vara de extensión, Rallonge

6-1898

Shut-oﬀ Handle

Mango de cierre

Poignée du robinet

6-3337

Straps

Tirantes

Sangles

For constant spraying, push down on shut-oﬀ

handle and move locking mechanism away

from you. To release, squeeze handle and

move the locking mechanism back towards

you.

6. Fatigue-Free Spraying

Note: Your particular sprayer may not include all parts pictured above.

Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.

Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.

6-5797

Nozzle .5GPM

Tobera

Buse

Polyethylene

Wide Mouth Sprayer

Pulverizador de polietileno

de boca ancha

Pulvériateur en polyéthylène

à grande ouverture

P.O. Box 549 700 Ellicott St.

Batavia, NY 14021-0549 U.S.A.

1-800-950-4458 www.chapinmfg.com

1 2

Summary of Contents

Page 1 - WARNING!

WARNING!Printed in U.S.A.1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet. 2) Do: Inspect hose for deterio

Page 2 - ADAVERTISSEMENT!

Printed in U.S.A.010538 (B) R02091) Sí: Veriﬁque el ajuste de la tuerca de la manguera para asegurarse de que la manguera esté unida correctamente a

Comments to this Manuals

No comments

Chapin 22090 User Manual

Browse online or download User Manual for Water equipment Chapin 22090. Chapin 22090 User Manual [en]

Summary of Contents

Comments to this Manuals

Related products and manuals for Water equipment Chapin 22090